Page 1 of 1
Main table insert for tablesaw
Posted: Thu Oct 04, 2012 11:50 pm
by creekrunner
Just acquired an 83 model. Main table missing insert and two screws that hold it in. Anyone on here parting one out? Checked ebay but don't want to go there unless I have to.
Also looking for a good 6" face plate.
David
Posted: Fri Oct 05, 2012 12:11 am
by curiousgeorge
Look
HERE for the inserts and
HERE for the faceplate. That should fix you up, David.
Parts
Posted: Fri Oct 05, 2012 9:26 am
by creekrunner
Thanks curiousgeorge, I had found where to buy new and certainly will do that if I have to but I was trying to maybe help out someone on this site that was or is parting out a machine or two.
David