Shopsmith Forums

Hello All;

I recently restored and upgraded my 1987 510 to a 520 and am getting ready to redo a 10 ER. I am looking for an original set of legs and casters and also a table for my beltsander and an 18 inch jigsaw to round out my attachments any help would be appreciated..

I can be contacted at eric.hovan@ventrac.com or (c)330-401-9224

Best Regards

Eric

Might help to add your location to your profile so folks know where you are located. The jigsaws come up on E-Bay fairly regularly and usually sell for $75-$100 in good condition. When you say you want a table for your belt sander, do you mean a table to store it on when not in use or a power bench to operate it independently of the SS?

I actually need the table and two posts that hold the work piece on the beltsander itself, mine got lost in my move when I retired from the service.

Best Regards

Eric