Shopsmith Forums

Hello everyone
A while back someone made an adaptor so that a steel lathe tail stock could be used on the ShopSmith. I can not find this artical in the archives.
If anyone know where I can find the info. I would be Greatfull.
C.A.G.

curtisgeorge wrote:Hello everyone
A while back someone made an adaptor so that a steel lathe tail stock could be used on the ShopSmith. I can not find this artical in the archives.
If anyone know where I can find the info. I would be Greatfull.
C.A.G.

I think this is the thread you are looking for: http://shopsmith.net/forums/showthread. ... lta+46-460

Or maybe this one. http://www.shopsmith.net/forums/showpos ... ostcount=2

Al

Thank you.
I had not seen the first link, but the second one was what I was looking for.
I thank you for all the help.
C.A.G.