Shopsmith Forums

Posted: **Wed Nov 28, 2012 5:47 pm**

Anyone have one to sell or know where to get one? This is the feed motor for the Pro Planer. Labeled Shopsmith, 115V Inout, DC motor, 0.5 Amp, 1/20 HP 3000 RPM, 18.48:1 ratio.
Mine is burned out and I really don't want to pay $470 for a new one.
Thanks

Posted: **Wed Nov 28, 2012 7:26 pm**

mrsmee wrote:Anyone have one to sell or know where to get one? This is the feed motor for the Pro Planer. Labeled Shopsmith, 115V Inout, DC motor, 0.5 Amp, 1/20 HP 3000 RPM, 18.48:1 ratio.
Mine is burned out and I really don't want to pay $470 for a new one.
Thanks

Have you checked the brushes?

Posted: **Wed Nov 28, 2012 8:01 pm**

mrsmee wrote:Anyone have one to sell or know where to get one? This is the feed motor for the Pro Planer. Labeled Shopsmith, 115V Inout, DC motor, 0.5 Amp, 1/20 HP 3000 RPM, 18.48:1 ratio.
Mine is burned out and I really don't want to pay $470 for a new one.
Thanks

I think Bill Mayo probably has one. I think I had asked him when I was looking to buy a machine without one. Look him up under the member list.

Posted: **Thu Nov 29, 2012 7:04 am**

letterk wrote:I think Bill Mayo probably has one. I think I had asked him when I was looking to buy a machine without one. Look him up under the member list.

This is Bill's email address (taken from his signature on his last post to the forum).

[bill.mayo@verizon.net]

Shopsmith Forums

I need a Pro Planer feed motor

I need a Pro Planer feed motor