Page 1 of 1
incra v120 shopsmith miter gauge
Posted: Tue Dec 25, 2012 12:38 am
by eagleta2
Hi everyone
I'm just curious if anyone has invested in an incra v120 shopsmith miter gauge?
Are you pleased with your purchase? Do you get the dead on accuracy that is advertised?
Im just thinking of treating myself to a Christmas present and this is on the list of things to look at.
Thanks in advance
Geo
Posted: Wed Dec 26, 2012 3:19 pm
by mackeydoc
eagleta2 wrote:Hi everyone
I'm just curious if anyone has invested in an incra v120 shopsmith miter gauge?
Are you pleased with your purchase? Do you get the dead on accuracy that is advertised?
Im just thinking of treating myself to a Christmas present and this is on the list of things to look at.
Thanks in advance
Geo
I am using the Incra v 120 miter gauge. Love it! Once I got used to adjusting the rail for "snuggness" in the miter slot no problems! I have it with the safety handle as well.
Mackeydoc
Posted: Wed Dec 26, 2012 5:43 pm
by mountainbreeze
I have the V120 and I like it. Had to spend a little time setting it up but now that that is done, it works great. Check out
this thread I started when I got mine.
Posted: Wed Dec 26, 2012 7:39 pm
by jctorok
I love the V120, it made cutting angles easier and more accurate. I use the V120 both in my Shopsmith miter slot and on a Miter Express.
I attached a picture so you can see the set up.
[ATTACH]19691[/ATTACH]
Posted: Wed Dec 26, 2012 8:28 pm
by reible
I have one on a wish list but it is pretty far down. I have the shopsmith 2000 version and the 1000HD I use on my miter express so I'm not in a rush.
To be honest I still use the shopsmith miter gauge for most things and I'm pretty happy with it. I also have a lot of add-on's for the shopsmith miter gauge which would require a good deal of work to remake to use with the Incra.
Ed