Page 1 of 1
What is it?? I found this in the box that accompanied my used SS
Posted: Sat Dec 29, 2012 4:24 pm
by randyrls
I found in a box with my SS. The question is "What is it"? It is about 4-1/4" x 1-1/4" and has a bevel on one end. There was a 1/4" carriage bolt thru the one hole as you see and that hole is square and matches the square porrtion of the carriage bolt head.
But I have no idea of what it is or where it goes.
Any suggestions are appreciated.
Happy New Year!
Posted: Sat Dec 29, 2012 4:38 pm
by algale
randyrls wrote:I found in a box with my SS. The question is "What is it"? It is about 4-1/4" x 1-1/4" and has a bevel on one end. There was a 1/4" carriage bolt thru the one hole as you see and that hole is square and matches the square porrtion of the carriage bolt head.
But I have no idea of what it is or where it goes.
Any suggestions are appreciated.
Happy New Year!
That looks like part of the lower saw guard: it is part of the clamp that holds the upper saw guard/riving knife in place. Parts 207 and 208 and 210 on this:
http://www.shopsmith.com/ownersite/part ... xpview.htm
Posted: Sat Dec 29, 2012 5:17 pm
by robinson46176
I didn't recognize what it was but I did know right off that I needed at least 4 of them...
.
Posted: Sun Dec 30, 2012 10:06 am
by randyrls
Thank you! I looked at everything I had on the SS, but didn't notice that part.
Off to church now....