Shopsmith Forums

Posted: **Sun Jan 20, 2013 5:05 pm**

Does anyone have the mounting holes position needed to mount a wheel retract system on a power stand. And can u use the retract stand from the mark V/7 stands?

RICK

Posted: **Sun Jan 20, 2013 8:41 pm**

onevw wrote:Does anyone have the mounting holes position needed to mount a wheel retract system on a power stand. And can u use the retract stand from the mark V/7 stands?

RICK

Which power stand? Scroll saw = no.

The holes should pre-exist if the m5/V/VII/7 casters fit.

Posted: **Sun Jan 20, 2013 8:51 pm**

JPG40504 wrote:Which power stand? Scroll saw = no.

The holes should pre-exist if the m5/V/VII/7 casters fit.

For the pro planer

Posted: **Sun Jan 20, 2013 10:08 pm**

onevw wrote:For the pro planer

http://www.shopsmith.com/ownersite/catalog/pl_casters.htm

The casters are used almost everywhere. The extra spacers accommodate wider stands.

Shopsmith Forums

Retracts added to power stand

Retracts added to power stand