Page 1 of 1
Sanding Question
Posted: Mon Feb 18, 2013 7:33 pm
by terryvance
Does Shopsmith make something to connect the disc sander to a dust collection system. I am not having any luck finding something on the Shopsmith web site.
Posted: Mon Feb 18, 2013 7:55 pm
by beeg
Posted: Mon Feb 18, 2013 8:28 pm
by john
That's what I use on my model 510. Make sure you get one for your model.
John
Posted: Mon Feb 18, 2013 8:40 pm
by terryvance
Thank you. I could not find the thing. My search skills need improving. I am sure I will get one.
Thanks again.
Posted: Tue Feb 19, 2013 5:13 am
by dusty
terryvance wrote:Thank you. I could not find the thing. My search skills need improving. I am sure I will get one.
Thanks again.
Search skills or sanding disk??:rolleyes:
I use the lower saw guard that fits my 510 and it works well with the Shopsmith DC but isn't very effective with my Shopvac. The Shopvac doesn't move enough air.
Posted: Tue Feb 19, 2013 8:06 am
by terryvance
dusty wrote:Search skills or sanding disk??:rolleyes:
I use the lower saw guard that fits my 510 and it works well with the Shopsmith DC but isn't very effective with my Shopvac. The Shopvac doesn't move enough air.
I tried the lower saw guard and the sanding disc would not go into it. I guess Shopsmith must have redesigned the thing at some point. The 10" saw blade will go in but the 12" sanding disc will not. Oh well, it's only money.....
I found an old issue of Wood magazine with a plan for a dust collector that I plan to make sometime this spring.
Posted: Tue Feb 19, 2013 1:26 pm
by JPG
terryvance wrote:I tried the lower saw guard and the sanding disc would not go into it. I guess Shopsmith must have redesigned the thing at some point. The 10" saw blade will go in but the 12" sanding disc will not. Oh well, it's only money.....
I found an old issue of Wood magazine with a plan for a dust collector that I plan to make sometime this spring.
The older aluminum disk will not fit. The blade guard needs to be opened fully. There is potential interference inside.
The pre 510 guard will not work. The 500 chute is used only from the side of the table.
Posted: Tue Feb 19, 2013 1:37 pm
by terryvance
Mine is steel but still does not fit.
Posted: Tue Feb 19, 2013 2:29 pm
by JPG
terryvance wrote:Mine is steel but still does not fit.
There are a couple of pieces that need to be removed/altered.
When I get a chance, I will take pix to 'illustrate'.
The steel disk needs to have the longer hub.