Page 1 of 1
Greenie motor converting to a grinder
Posted: Tue Mar 05, 2013 4:17 pm
by wirtvz
I recently upgarded my 56' greenie motor and want to convert the old motor to a grinder. The problem is that I need help with the wiring. Which wire is then hot/ground after disconnecting the capacitor and the converter. There ai a green, a red and a yellowis with red markings coming out from the motor.
GE motor model 5XC39NG-202.
Posted: Thu Mar 07, 2013 2:37 pm
by peterm
Why did you disconnect the capacitor? And I do not recognize the term "converter"! I looked through my collection of Shopsmith info, but all I found was how to replace an off/on switch.......sorry.
Posted: Thu Mar 07, 2013 9:56 pm
by JPG
wirtvz wrote:I recently upgarded my 56' greenie motor and want to convert the old motor to a grinder. The problem is that I need help with the wiring. Which wire is then hot/ground after disconnecting the capacitor and the converter. There ai a green, a red and a yellowis with red markings coming out from the motor.
GE motor model 5XC39NG-202.
http://www.shopsmith.net/forums/showpos ... ostcount=2