Page 1 of 1
520 tube thumb screw(515859)
Posted: Sat Apr 27, 2013 10:19 pm
by JPG
Thread size and length?
I am looking for something to replace the Mark VII extension table/main table clamping screws/knobs.
Posted: Sun Apr 28, 2013 9:21 am
by reible
Hi,
To get you started it is a 1/4-20, I check the length when I get to the shop a bit later today.
Ed
Posted: Sun Apr 28, 2013 10:16 am
by JPG
reible wrote:Hi,
To get you started it is a 1/4-20, I check the length when I get to the shop a bit later today.
Ed
TIA!!!!!!!!!
Posted: Sun Apr 28, 2013 11:54 am
by reible
x 3/4", knob dia. = 1"
Ed
Posted: Sun Apr 28, 2013 12:33 pm
by JPG
reible wrote:x 3/4", knob dia. = 1"
Ed
That will work! Thanks again! Same as Band saw circle and table extension.