Page 1 of 1
Changing Morse taper
Posted: Tue Jul 30, 2013 8:49 pm
by stickthrower
I have a question: I picked up a mini lathe at an auction, and I am wondering how do you change out the live center and the drive? It looks like it has a morse taper on it. So I know it needs to slide out and slide the new end in, but I am not sure how.
I know, it isn't a shopsmith, but I am hoping someone on here has an idea on it.
Thanks.
Nathan
Posted: Tue Jul 30, 2013 8:56 pm
by JPG
A gentle tap to the back(in) end should release them. Be prepared to 'catch' it.
Posted: Tue Jul 30, 2013 8:58 pm
by stickthrower
thanks JPG! I was wondering that, but I wanted to ask before I did something that would completely mess me up.
It ended up being a deal I couldn't refuse. Even if I use it for nothing more than sanding, it has variable speed.
Nathan
Posted: Tue Jul 30, 2013 9:07 pm
by JPG
stickthrower wrote:thanks JPG! I was wondering that, but I wanted to ask before I did something that would completely mess me up.
It ended up being a deal I couldn't refuse. Even if I use it for nothing more than sanding, it has variable speed.
Nathan
I think in your case the answer is no, but does the lathe have a slot for a 'tang wedge' to drive them out. Larger metal working machines have the slots which allows for blind mounting.