couple of ideas needed
Posted: Sun Oct 13, 2013 8:23 pm
I made a large 24" round disc.
I need to make a stand for it to sit on a shelf.
I am thinking of just letting it lay on the shelf and have two holder on each side balance, and the lean back a little with somekinda support in the center.
very similar to a plate stand, just not sure of how to go forward?
TIA
I need to make a stand for it to sit on a shelf.
I am thinking of just letting it lay on the shelf and have two holder on each side balance, and the lean back a little with somekinda support in the center.
very similar to a plate stand, just not sure of how to go forward?
TIA