Page 1 of 1
Kreg Bandsaw Fence- need information
Posted: Sun Mar 02, 2008 4:19 pm
by backhertz
I received my new bandsaw fence. I had been backordered. I have no idea if everything came because there were no instructions. Anyone know a place on the Internet I could find some? Thanks.
Posted: Sun Mar 02, 2008 5:09 pm
by paulmcohen
There should have been two sets of instructions one from Shopsmith and one freom Kreg, the Kreg instructions are very bad be glad you did not get them. The Shopsmith instructions are marginally better. Email me and I can walk you through it. There are also several threads here with lots of pictures.
Posted: Sun Mar 02, 2008 5:25 pm
by mtobey
Once you get it on, you will really like it. I have one on my 14" standalone- my SS BS is castiron table. I am taking it off the 14" and adapting to the venerable Shopsmith.mt
Kreg Bandsaw Fence
Posted: Sun Mar 02, 2008 8:46 pm
by dusty
backhertz,
Check this site - under precision measuring equipment. You can download a PDF copy of the generic instructions. For Shopsmith specific info - you can take Paul up on his offer:
http://www.kregtool.com/information_cen ... -fence.pdf
http://www.kregtool.com/products/featur ... turet.html
Posted: Tue Mar 04, 2008 8:03 pm
by backhertz
Thanks guys. After I wrote the message, I was looking at the fence and found a picture. Afterall, 'real' men... About 30 minutes later, I had the fence mounted. Ended up with some extra hardware though. I figure Kreg supplied a generic hardware kit. I found the kit relatively easy to figure out. However, I knew I'd need the instructions to precisely set it up.
Posted: Wed Mar 05, 2008 12:50 am
by paulmcohen
backhertz wrote:Ended up with some extra hardware though. I figure Kreg supplied a generic hardware kit. I found the kit relatively easy to figure out. However, I knew I'd need the instructions to precisely set it up.
Setup is very easy, it is the extra hardware that I don't remember. Do you have any photos, especially of the left over pieces.