Page 1 of 1
Table question
Posted: Sat Jan 04, 2014 7:16 pm
by ipbarnard
Just wondering.
What are the two extra bolts on the bottom of my Mark V table for?
Thanks,
Foster From Flint
Posted: Sat Jan 04, 2014 7:38 pm
by beeg
Those are for when ya have it in drill press mode, so that the table is horizontal.
Posted: Sat Jan 04, 2014 7:59 pm
by reible
beeg wrote:Those are for when ya have it in drill press mode, so that the table is horizontal.
Those need to be adjusted as does the 45 degree stop. Part of a good check-up of the machines alignment.
Ed
Posted: Sat Jan 04, 2014 8:04 pm
by charlese
Yeah! What Beeg said! They ain't "extra" - they're necessary! I found them very useful.
Glad you looked down there!:D
Posted: Sat Jan 04, 2014 10:10 pm
by JPG
charlese wrote:Yeah! What Beeg said! They ain't "extra" - they're necessary! I found them very useful.
Glad you looked down there!:D
They be adjustable 'stops'.
