Page 1 of 1
Miter gage washer removal
Posted: Fri May 02, 2014 2:21 pm
by rmojo
Does anyone know what size allen I need to remove the washer on a 510 miter gage? I want to use the miter gage in my Ridgid table saw. The screw looks like an allen on mine but it looks a little chewed up(previous owner). I can't find the size anywhere in the literature. I don't want to chew it up anymore than it is. Thanks
Posted: Fri May 02, 2014 3:48 pm
by Mike907
3/32" in mine.
Mike
Posted: Fri May 02, 2014 3:51 pm
by dusty
rmojo wrote:Does anyone know what size allen I need to remove the washer on a 510 miter gage? I want to use the miter gage in my Ridgid table saw. The screw looks like an allen on mine but it looks a little chewed up(previous owner). I can't find the size anywhere in the literature. I don't want to chew it up anymore than it is. Thanks
An Xcelite LN-23 will do the trick. I found an online cross reference chart that says that is a 3/32" allen.
Posted: Fri May 02, 2014 5:16 pm
by reible
You can remove the washer but it is quite possible that the miter gauge will be a very sloppy fit. Shopsmith uses a smaller size bar then today's typical 3/4" size. I'm not a Ridge owner but I would be surprised if they compatible.
Ed
Posted: Sat May 03, 2014 2:47 am
by rmojo
Thanks for everyones response. After some fiddling I got it out. But reilble is correct. It does not work in the 3/4 miter slot in the table saw. It was worth a try because it is a superior miter gage than the one that came with the saw.
Posted: Sat May 03, 2014 9:37 am
by JPG
rmojo wrote:Thanks for everyones response. After some fiddling I got it out. But reilble is correct. It does not work in the 3/4 miter slot in the table saw. It was worth a try because it is a superior miter gage than the one that came with the saw.
Get a 10ER miter gauge(3/4" bar). The 'head' is very similar to a Mark x. The 10E miter gauge head is different.