Shopsmith Forums

Posted: **Fri May 16, 2014 3:19 pm**

Having purchased the Icra v120 miter I do not use my Incra 2000 with a shopsmith miter bar. More than happy to pass in on to anyone in the forum at no cost. I am in Virginia Beach Va. Just pick it up.

Rock

Old salt retired Master Chief USN (retired 1970)

Posted: **Fri May 16, 2014 3:52 pm**

rock wrote:Having purchased the Icra v120 miter I do not use my Incra 2000 with a shopsmith miter bar. More than happy to pass in on to anyone in the forum at no cost. I am in Virginia Beach Va. Just pick it up.

Rock

Old salt retired Master Chief USN (retired 1970)

GOOD BOY!!!!!!!!!!!!!!!!!!!

Posted: **Fri May 16, 2014 6:49 pm**

rock wrote:Having purchased the Icra v120 miter I do not use my Incra 2000 with a shopsmith miter bar. More than happy to pass in on to anyone in the forum at no cost. I am in Virginia Beach Va. Just pick it up.

Rock

Old salt retired Master Chief USN (retired 1970)

Rock, Does the fence from the Incra 2000 fit the v120 miter gauge?

Posted: **Sat May 17, 2014 8:01 am**

The fence for the v120 and 2000 fits both

Posted: **Sat May 17, 2014 9:28 am**

rock wrote:Having purchased the Icra v120 miter I do not use my Incra 2000 with a shopsmith miter bar. More than happy to pass in on to anyone in the forum at no cost. I am in Virginia Beach Va. Just pick it up.

Rock

Old salt retired Master Chief USN (retired 1970)

This retired fly boy would be there to get it today but Virginia Beach is a bit far. Very generous offer.

Posted: **Sat May 17, 2014 12:10 pm**

Save that miter bar for a crosscutting sled that you will eventually want to make.