Page 1 of 1
Mark V - Lathe - 4' stock turning
Posted: Thu Jun 12, 2014 12:26 pm
by panofraz
Has anyone been able to turn stock longer than the bed? I have some 1" doweling that is 4' long that I need to turn in a few places - to make a Sailor Pluto Time Key Staff for my daughter...
Posted: Thu Jun 12, 2014 1:36 pm
by Mike907
Probably easiest to cut cut the dowel where the joint could be hidden and turn the two pieces separately, but you could do something like
this.
Mike
Posted: Thu Jun 12, 2014 3:01 pm
by panofraz
Thanks Mike....I like the pillow block idea....
Brad:)
Posted: Sat Jun 14, 2014 3:30 pm
by letterk
panofraz wrote:Has anyone been able to turn stock longer than the bed? I have some 1" doweling that is 4' long that I need to turn in a few places - to make a Sailor Pluto Time Key Staff for my daughter...
It has been done with combining two Shopsmith beds together or replacing the center with another fixed center.
Here is an extreme example.
http://www.youtube.com/watch?v=rQbzEz0-7X0