Page 1 of 3
Semi Shorty ER 10
Posted: Sat Aug 09, 2014 11:13 pm
by "Wild Bad Bob"
I cut the base to a total length of 39.5", moved the base plate in 3.25", looked good there, moved the head rest to the inside of the motor, 36" from the right side, (base plate end).
Hope not
Posted: Sun Aug 10, 2014 9:34 pm
by e.friedl
The pictures don't show it but I hope you didn't cut down 10ER tubes. You will get a lot of flack if you did. Being thicker they are in great demand. Mark V tubes would have probably worked just as well for a short span of a mini.
All of that said personally I defend your right to do as you please, just expect some flack.
Ed
Posted: Sun Aug 10, 2014 10:52 pm
by "Wild Bad Bob"
EF, No way I cut the tubes, my torch wont cut then!!!! I just made the support base shorter!!!
Posted: Sun Aug 10, 2014 11:04 pm
by "Wild Bad Bob"
Big boys, no comment!!
Posted: Sun Aug 10, 2014 11:26 pm
by skou
I'm not that big, but I think you "done" good!
Takes up less room in D-P mode, and you didn't cut the tubes.
2 thumbs up.
steve
Posted: Mon Aug 11, 2014 12:07 am
by "Wild Bad Bob"
SKOU, thought I was banished here!!!!!!!!!!! No replies, Must be at County Fairs!!!
Posted: Mon Aug 11, 2014 12:17 am
by JPG
I still think a tie bar at the headrest is a good idea even though it could get in the way when raised for drill pressing. I am 'out of town' so tardy 'response' is 'understandable'. That's 'my' excuse!:rolleyes:
Posted: Mon Aug 11, 2014 12:21 am
by "Wild Bad Bob"
JPG, that is WiFi is for!!!, got to look at the o;d PDF specs and your terms.
Posted: Mon Aug 11, 2014 12:25 am
by "Wild Bad Bob"
JPG, the light is always on!! So move the "tie bar" into ,closer. to the HEAD??
Posted: Mon Aug 11, 2014 12:26 am
by JPG
[quote="rbursek"]JPG, that is WiFi is for!!!, got to look at the o]
http://www.merriam-webster.com/dictionary/exacerbate;)