Page 1 of 2
Looking for a 10er Lathe tool rest.
Posted: Fri Aug 22, 2014 9:24 pm
by paulsgreenbarn
I'm giving one of my 10er's to my brother .He wants to use it as althe mostly and I need a tool rest.If you have one you can part with,email me at
paulsgreenbarn@roadrunner.com with info.Thanks
Posted: Sat Aug 23, 2014 2:07 am
by skou
Paul, what exactly do you need? A model 10 tool rest (like all the other Shopsmith tool rests) is 2 parts. Do you need the base or the actual rest?
I may be able to help you out.
steve
Posted: Sat Aug 23, 2014 2:32 am
by "Wild Bad Bob"
Skou,
good morning!! Are the er and mark v tool rest inter changeable?
Posted: Sat Aug 23, 2014 2:37 am
by JPG
rbursek wrote:Skou,
good morning!! Are the er and mark v tool rest inter changeable?
The 'base', no.
IIRC the actual tool rest has the same size post.
Good Night!!!!:p
Posted: Sat Aug 23, 2014 4:39 am
by skou
JPG is right. The lower half, (if I'm not mistaken) has grooves cut in it, like the table raising teeth on the front carriage post. The upper half is the same.
I (think) I have a couple extras, so, let me know. I won't charge more than 3 or 4 hundred more (or just shipping) for them.
(They are antiques, you know!)
steve
Posted: Sat Aug 23, 2014 4:42 am
by skou
Oh, Dusty, is this too much "chat room" for you?
If it is, I'm (not) sorry.
It also is "woodworking" so it needs to be moved!
steve
Posted: Sat Aug 23, 2014 4:45 am
by skou
rbursek wrote:Skou,
good morning!! Are the er and mark v tool rest inter changeable?
Why ask me? I don't pertain to Mark series stuff!:D I do know that the ER stuff is compatible with the ER stuff. (Sorry Dusty, more "chat room" stuff.)
steve
Posted: Sat Aug 23, 2014 5:17 am
by "Wild Bad Bob"
I thought you may know, but right the MV stem is not smooth, made to fit in the TS carriage.
Posted: Sat Aug 23, 2014 7:56 am
by paulsgreenbarn
thanks guys.I just need the top tool rest portion,if anyone has one.I have the base .
Posted: Sat Aug 23, 2014 8:58 am
by henecle
They're on eBay all the time...