Page 1 of 1
scroll saw shaft mark V500
Posted: Mon Aug 25, 2014 1:57 pm
by bobpjr
the gear on the shaft of my scroll saw does not engage the nearby gears. it looks like perhaps it has slid about 1/2 inch down the shaft. I can find no way to move it back or adjust it. any ideas???
Posted: Mon Aug 25, 2014 3:56 pm
by joedw00
Welcome to the forum. Pictures would up.
Posted: Tue Aug 26, 2014 4:46 pm
by wa2crk
http://www.shopsmith.net/forums/showthr ... ll+rebuild
Bob.
You may want to try the link for the rebuild thread on this forum. (posted above) We like pictures so if you can post a few it would be a help.
Bill V