Page 1 of 2
10ER Lower saw guard....
Posted: Wed Sep 24, 2014 7:03 pm
by rjent
I keep hearing about dust collection and the lower saw guard for
Ciannait (My 10ER) Is there such a thing? I have looked and I don't think it would be too hard to make one. Just curious. Any pictures? I can't seem to find a pic anywhere ....
Posted: Wed Sep 24, 2014 8:36 pm
by henecle
One just sold the other day... I guessed it would go for around $150, it was close.
http://www.ebay.com/itm/Original-SHOPSM ... 4adc5d27a5
Posted: Wed Sep 24, 2014 11:38 pm
by rjent
Well, isn't that something! I have searched and searched ebay and that is the first one I have seen. Pretty pricey. I have an idea about making one with DC. I will work on it!
Thanks henecle for the heads up!
Dick
Posted: Thu Sep 25, 2014 9:06 am
by eartigas
rjent wrote:Well, isn't that something! I have searched and searched ebay and that is the first one I have seen. Pretty pricey. I have an idea about making one with DC. I will work on it!
Thanks henecle for the heads up!
Dick
144 bucks? That's a lot of cash.
One of my 10ER came with a saw guard (or disk sander guard?) but looked like a Mark 5 adaptation.
Posted: Thu Sep 25, 2014 5:20 pm
by JPG
eartigas wrote:144 bucks? That's a lot of cash.
One of my 10ER came with a saw guard (or disk sander guard?) but looked like a Mark 5 adaptation.
"rare' items are not 'cheap'.
Posted: Fri Sep 26, 2014 6:35 am
by eartigas
I wonder when they started making it as the original manual says there is none and would be too cumbersome or something similar to that effect.
Historians?
Posted: Fri Sep 26, 2014 12:30 pm
by JPG
eartigas wrote:I wonder when they started making it as the original manual says there is none and would be too cumbersome or something similar to that effect.
Historians?
"
CAUTION Because it is not practical to completely guard that portion of the saw underneath the table, the user is cautioned not to make adjustments while the saw is in motion."
p 6 10E Owner's Guide circa 1947
Posted: Mon Sep 29, 2014 9:51 am
by eartigas
Exactly!:D
Posted: Mon Sep 29, 2014 8:33 pm
by rjent
" wrote:"CAUTION Because it is not practical to completely guard that portion of the saw underneath the table, the user is cautioned not to make adjustments while the saw is in motion."
p 6 10E Owner's Guide circa 1947
Ah but grand poopah, lower guard is good for dust collection with place for hose ....
Posted: Mon Sep 29, 2014 10:03 pm
by JPG
rjent wrote:Ah but grand poopah, lower guard is good for dust collection with place for hose ....
I don't suppose you noticed the 'shape' of the 'hose' connection.
More of a saw dust concentrator/deflecter than a vacuum connection.
An early Mark 5 lower guard
MAY work on a 10E/R with some modification. I have not tried it.