Don't try this at home :)
Posted: Thu Apr 30, 2015 12:57 am
Me and poppa smurf, where playing around on my Mark V. Yes, that was poppa smurf and not me, I was just the camera man 
Shopsmith Forums
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Don't try this at home :)
Page 1 of 2
Re: Don't try this at home :)
Posted: Thu Apr 30, 2015 6:39 am
...and?
Re: Don't try this at home :)
Posted: Thu Apr 30, 2015 1:29 pm
Must have been a lot of fun???????
Re: Don't try this at home :)
Posted: Thu Apr 30, 2015 1:33 pm
So did ya both do a disappearing act or get too close to a plasma bubble?
Re: Don't try this at home :)
Posted: Thu Apr 30, 2015 5:59 pm
Extramile is a magician, guys.
Re: Don't try this at home :)
Posted: Thu Apr 30, 2015 7:19 pm
Now I want to know if Smurfs really exist. Where are the pics?
Re: Don't try this at home :)
Posted: Thu Apr 30, 2015 7:36 pm
OK, everyone is replying. Did the OP have pictures? I don't see them.ExtraMile wrote:Me and poppa smurf, where playing around on my Mark V. Yes, that was poppa smurf and not me, I was just the camera man
Re: Don't try this at home :)
Posted: Thu Apr 30, 2015 9:47 pm
NOjsburger wrote:OK, everyone is replying. Did the OP have pictures? I don't see them.ExtraMile wrote:Me and poppa smurf, where playing around on my Mark V. Yes, that was poppa smurf and not me, I was just the camera man
Re: Don't try this at home :)
Posted: Fri May 01, 2015 9:08 am
Ever hear of Schrodinger's cat?
Re: Don't try this at home :)
Posted: Sat May 02, 2015 1:53 am
Oops, the picture didn't load!
This branch, was first cut on my power miter, then centers located and then loaded onto the lathe.
The first try, the thing zinged off of the lathe! Soon, we figured it out that the curved portion needed to be trimmed off.
We then screwed it fast onto a faceplate and began turning!
It is Mulberry and it has a gorgeous grain!
No, it is not done. It is still to green. But I just had to see what it looked like, turned. This branch was the sacrificial lamb
This branch, was first cut on my power miter, then centers located and then loaded onto the lathe.
The first try, the thing zinged off of the lathe! Soon, we figured it out that the curved portion needed to be trimmed off.
We then screwed it fast onto a faceplate and began turning!
It is Mulberry and it has a gorgeous grain!
No, it is not done. It is still to green. But I just had to see what it looked like, turned. This branch was the sacrificial lamb