Page 1 of 1
What is this?
Posted: Tue May 26, 2015 9:28 am
by dgreen810
I got this item with a SS 510 I recently purchased. Can someone tell what it is, how it is used and a part number?
Don G
Re: What is this?
Posted: Tue May 26, 2015 9:43 am
by JPG
Re: What is this?
Posted: Tue May 26, 2015 12:56 pm
by dgreen810
OK James
You have identified it as a Miter Pro. I have located all the pieces but since it has a multitude of holes and slots, do you happen to have a schematic of how this sucker goes together? The picture of the 555404 you posted just leaves you wondering.
Don G
Re: What is this?
Posted: Tue May 26, 2015 12:58 pm
by forrestb
Huh! And I thought it was an ashtray for short cigarettes!
Forrest
Re: What is this?
Posted: Tue May 26, 2015 1:13 pm
by dusty
Really now. By the time I can get a tell tale photograph posted here on the forum, you should have the three pieces (excluding the stop) all mounted. It forms a 90° fence that slides in the miter slot. Maybe there are four pieces if the one shown above does not have the miter rail attached.
If you have not already finished, you might want to read through this thread.
http://www.shopsmith.com/ss_forum/viewtopic.php?t=2725
Re: What is this?
Posted: Tue May 26, 2015 1:30 pm
by dgreen810
I think this is the way, if not someone correct me.
Don G
Re: What is this?
Posted: Tue May 26, 2015 4:13 pm
by JPG
Looks good to me(except for the adhesive).
