Page 1 of 1
Miter gauge with hold down fir 10er
Posted: Tue Jul 21, 2015 8:46 pm
by dlewis
Will later miter gauges fit the 10er, or is the table slot a different size?
I am in need of one. I note they are a bit pricey in eBay.
Don
Re: Miter gauge with hold down fir 10er
Posted: Tue Jul 21, 2015 10:36 pm
by JPG
dlewis wrote:Will later miter gauges fit the 10er, or is the table slot a different size?
I am in need of one. I note they are a bit pricey in eBay.
Don
The "10" miter gauge bar is 3/4" wide. Mark 5... miter gauge bars are slightly narrower.
Also the "10" miter gauge bar is 1/4" thick. The Mark 5... is thicker.
That means the "10" miter gauge slot is shallower.
Re: Miter gauge with hold down fir 10er
Posted: Tue Jul 21, 2015 11:10 pm
by reible
I have not tried this but I think it being made by Skip pretty much says it will work fine.
http://mkctools.com/10ermiterbarmv.htm
Ed
Re: Miter gauge with hold down fir 10er
Posted: Wed Jul 22, 2015 12:30 pm
by dlewis
Thanks for the help.
Dom