Page 1 of 1
jointer guard assembly on 1981 jointer
Posted: Thu Sep 03, 2015 10:35 pm
by alisfair
Have a jointer and can't figure out how the guard is put together. I believe the spring fits in the top part then the washer. Know it screws into nut then put into the table. Anyone have any ideas?
Thanks,
Tom
Re: jointer guard assembly on 1981 jointer
Posted: Thu Sep 03, 2015 11:03 pm
by BuckeyeDennis
Check out the exploded view and parts list
here on the SS web site. Do they answer your question? I have the new-style finger-board guard, so I'm not sure if the assembly is the same for the older porkchop guards.
Re: jointer guard assembly on 1981 jointer
Posted: Thu Sep 03, 2015 11:11 pm
by JPG
Assuming you have the older version.
- JOINTER GUARD EXPLODED.jpg (211.83 KiB) Viewed 2950 times
If not,
http://www.shopsmith.com/service/jointe ... iagram.htm
Re: jointer guard assembly on 1981 jointer
Posted: Fri Sep 04, 2015 7:58 pm
by alisfair
Thank you for the blown up drawing. Got it to work even though I did not have what looked like a lock washer. It worked!!! Thanks a bunch.
Tom