Shopsmith Forums

Posted: **Fri Oct 16, 2015 6:37 pm**

Anyone have a use for the old bandsaw table? Just got the new table and need a use for the old one.
Ideas?

Posted: **Fri Oct 16, 2015 8:04 pm**

I sure do, mine is BENT. The cast iron. Seriously. Took me quite a few cuts to figure out why they were always off. I thought blade wander, user error, finally realized someone very heavy jumped on the near edge. Makes it hard to cut a 90 degree side when it bends down on the near side of the blade. I'll PM you.

Shopsmith Forums

Any new use for old bandsaw table?

Any new use for old bandsaw table?

Re: Any new use for old bandsaw table?