Page 1 of 1
replacing spring #504196
Posted: Tue Oct 20, 2015 5:46 pm
by Bart52
I had to replace all of the bearings on my 1957 model Mark V. "long story short" I do not remember where spring #504196 goes on the speed control. Can some send me a pic of its position?
Re: replacing spring #504196
Posted: Tue Oct 20, 2015 6:02 pm
by JPG
See third pix. It is 'upside down'.
http://www.shopsmith.com/ss_forum/viewt ... #post40966
More often it just gets lost. That is the 'anti-rattle' spring.
IMHO it is the speed going past saw-joint tactile feedback spring.
