Page 1 of 1
Found part, need help identifying
Posted: Sun Dec 13, 2015 2:04 pm
by Beave2012
Just found this laying in my SS cabinet. Not sure what this came out of, hoping one of you recognise it.
- IMAG0344-1280x720.jpg (125.98 KiB) Viewed 974 times
Found it where I store the saw blades, arbors, safety stuff, etc... But it is also right under the shopsmith. The top of the bolt is not slotted, it's Smooth and the are slight "wings" off the head.
Re: Found part, need help identifying
Posted: Sun Dec 13, 2015 2:07 pm
by algale
That looks like part of the plastic featherboard. Inserts through the bottom of the plastic featherboard's short plastic miter bar.
Re: Found part, need help identifying
Posted: Sun Dec 13, 2015 2:57 pm
by dusty
algale wrote:That looks like part of the plastic featherboard. Inserts through the bottom of the plastic featherboard's short plastic miter bar.
Right on!
Re: Found part, need help identifying
Posted: Sun Dec 13, 2015 8:31 pm
by Beave2012
Exactly it, thanks for helping me out on that. Would have been a while before I found that out. (i have multiple feather boards)
Thanks