Shopsmith Forums

Posted: **Sun May 11, 2008 9:58 am**

G'day folks, Please excuse me if I am doing this wrong but I have only just signed on as a member and am unsure how to post a message/question. I live in Adelaide, South Australia, I am a Technical Studies teacher (Woodwork, Metalwork etc) and this weekend bought a "Shopsmith 10E", Serial#2381 and have just been searching the net for information about the machine, when I came across your forum. Are "owners manuals or information about the 10E" still available?

Posted: **Sun May 11, 2008 10:28 am**

Welcome from across the ditch (NZ).
I am sure some here will point you in the right direction.
Regards
Sandy

Posted: **Sun May 11, 2008 11:35 am**

Shopsmith has a note about the 10E and 10ER at

http://www.shopsmith.com/ownersite/faq/10er.htm

Also check

http://www.songofthegreatlakes.com/ss10er.htm

Good luck.

Fred

Posted: **Sun May 11, 2008 12:09 pm**

Welcome to the forum Scruffy!

You might want to check out http://www.ssug.org/. They have a section on 10E/10ER publications.

Again welcome to the group,

Denns

Posted: **Mon May 12, 2008 5:56 pm**

the best source of material on the er is on e-bay manuals and spare parts just tpye in shopsmith. then look under shopsmith e-bay. welcome to the forums. one of the best source of imformation available is this forums. great folks on here.

Posted: **Mon May 12, 2008 8:35 pm**

Check out this 10E/ER site, moderated by 10ER guru Skip Campbell from Texas,USA. There's lots of discussion, photos, info on parts, history, modifications, manuals, etc. http://www.groups.yahoo.com/group/shopsmith10erusers/ There is also a sister site on Yahoo for MkV's.