anyone have extra jointech parts?
Posted: Mon Aug 15, 2016 1:13 pm
Bought a second shopsmith to salvage its 520 table, pro router fence, and a jointech saw train system that was kind of complete.
as far as i can tell i'm definitely missing
1) clincher board. Can i use an incra or a jointech IPM2 instead? seems theyll be compatible.
2) the router lift. I have a jessum mast-r-lift 2 so this may not be important.
3) rails or at least one. one side of the saw train board fits perfectly on the angled piece of the shopsmith. the side with the handle doesn't seem to fit this rail. i can fix this by just printing a small block to slip inside the gap. still, extra rails would be a plus.
its likely the saw train doesn't fit this set of rails, but very confusing because the router table that came with it clearly has shopsmith 520 rails on it. I've read a lot of the posts here but haven't seen exactly why mine doesn't work.
if you or anyone you know has extra parts please private message me and we can work out logistics.
as far as i can tell i'm definitely missing
1) clincher board. Can i use an incra or a jointech IPM2 instead? seems theyll be compatible.
2) the router lift. I have a jessum mast-r-lift 2 so this may not be important.
3) rails or at least one. one side of the saw train board fits perfectly on the angled piece of the shopsmith. the side with the handle doesn't seem to fit this rail. i can fix this by just printing a small block to slip inside the gap. still, extra rails would be a plus.
its likely the saw train doesn't fit this set of rails, but very confusing because the router table that came with it clearly has shopsmith 520 rails on it. I've read a lot of the posts here but haven't seen exactly why mine doesn't work.
if you or anyone you know has extra parts please private message me and we can work out logistics.