Shopsmith Forums

Does anyone have pdfs or some high res pictures of the featherguard upgrade kit installation instructions for the jointer?

Much appreciated if you could provide them to me.

Cheers!
John

Well, if no one has any readily available instructions, can anyone explain or grab a quick picture as to how the locking nut/hand knob mechanism is secured to the table?

Is it simply screwed into a tapped hole into the in-feed table off of little peninsula?

A picture of how it is secured to the infeed table with feather guard assembly would be much appreciated!

Cheers,
John

Never laid eyes nor hands on one.

However since it is a 'retro kit', I presume it fits into the hex shaped hole the same as the 'original'.

What is 'added' is the tapped hole for the stud that allows locking it in position(rotation).

hope this is what your looking for.

Exactly what I needed trjohns! Thank you much!