Shopsmith Forums

I am relatively new to shopsmiths but seem to have caught the bug.

reading the posts here has been very educational and, FWIW, I add my thanks for all of the good info.

I am looking for advice on what issues to check for when looking at a used Mark V that someone is trying to sell.

from reading here and on the yahoo groups, it seems that the first 2 issues are rust and sawdust packed in the headstock.

assuming I got those right, what should I be looking for next?

is there anything in particular that says "run away" or that it is only good for parts?

thanks,
Ivan
Hampton,VA
Mark V (84) w/ jigsaw, belt sander, strip sander
ER10 awaiting restoration

Here are some things to look for. http://www.shopsmith.net/forums/showthr ... #post18018

Good Luck!

thanks for the info.

Ivan

Hi Ivan!
There is practically no Mark V that is not repairable. All replacement parts are available, so at the very worst, it will just cost money.

Besides looking for rust and checking the headstock for sawdust, you might plug it in and run it through its entire speed range. Listen to it as you turn the dial to ensure a different pitch as you change the speeds.

Mind you, Ivan, replacing a worn-out speed control is a relatively easy and inexpensive repair. The bigger trouble signs would be shot bearings, a bad motor, or a bent spindle.

Ivan, in the next Sawdust Session, (#21), I'm starting a series on purchasing, restoring, and upgrading older machines. The very first session -- this Saturday -- address your concern, what to look for when shopping for an older machine. It will include a checklist. If you're not registered for the on of the sessions -- I'm pretty sure both are full -- look for it on line next week.

With all good wishes,