Page 1 of 6
New bandsaw table not level
Posted: Sat Sep 03, 2016 9:41 pm
by putttn
Got a new aluminum bandsaw table and noticed the left rear corner is a good 1/16 low. Put my Woodpeckers 1281 on the table and its low in just that corner. I had the same problem with the cast iron table and thought this table would solve it. No such luck. I have the screw attach d in the rear middle groove. Dissappointing.
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:24 pm
by JPG
Not level, or not flat?
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:27 pm
by putttn
Not flat. Lest rear corner is "sagging"
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:34 pm
by JPG
putttn wrote:Not flat. Lest rear corner is "sagging"
How far from the corner is it 'not' sagging?
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:41 pm
by putttn
starts sagging about 1" behind blabe and 1" to the left of the blade.
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:43 pm
by putttn
Just purchased it this year
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:45 pm
by JPG
I think I would be disappointed as well. Have you discussed it with the mother ship?
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:48 pm
by putttn
Will do on Tues
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 10:49 pm
by Skizzity
I have the same problem with my main table. A serious sag in the middle around the insert. I feel your pain.
Re: New bandsaw table not level
Posted: Sat Sep 03, 2016 11:10 pm
by putttn
Seems like you couldnt get a square cut