Page 1 of 1
jigssaw part
Posted: Thu Oct 20, 2016 6:23 pm
by hobbies
does anyone knows where i can get the plastic part that make the blade go up and down on 18 inch jig saw dont have part number
Re: jigssaw part
Posted: Thu Oct 20, 2016 6:36 pm
by jsburger
hobbies wrote:does anyone knows where i can get the plastic part that make the blade go up and down on 18 inch jig saw dont have part number
The plastic part?
Please explain.
Re: jigssaw part
Posted: Thu Oct 20, 2016 6:40 pm
by hobbies
goes inside the main unit on the botton
Re: jigssaw part
Posted: Thu Oct 20, 2016 6:48 pm
by Mike907
Do you mean the part being fabricated in this video?
https://www.youtube.com/watch?v=Rb17icIjzeA
If so, it's a Yoke Bracket Assembly, part no. 502275, and not available as far as I know.
Mike
Re: jigssaw part
Posted: Thu Oct 20, 2016 7:16 pm
by hobbies
yes
Re: jigssaw part
Posted: Thu Oct 20, 2016 7:24 pm
by hobbies
does this have to be plastic?
Re: jigssaw part
Posted: Thu Oct 20, 2016 9:42 pm
by Mike907
I notice that in a four year old comment beneath the video, Skip Campbell at MKC Tools had made some and had them in stock. I couldn't find them listed on his site, but you could give him a call.
http://mkctools.com/
Mike
Re: jigssaw part
Posted: Fri Oct 21, 2016 1:11 pm
by jsburger
hobbies wrote:goes inside the main unit on the botton
Oh, OK. I haven't looked in there in a long time.
Re: jigssaw part
Posted: Sat Oct 22, 2016 12:52 am
by everettdavis
The video show how to fabricate one out of a piece of cutting board plastic in about 10 minutes.
I have a brand new OEM part on a NOS Jig Saw I bought last week and was thinking of making one of those due to the age of the plastic.
Everett
Re: jigssaw part
Posted: Thu Nov 10, 2016 6:05 pm
by hobbies
why is it so loud?