Shopsmith Forums

Can Anyone Tell Me What A Model 10e Is Worth,

As much as someone will pay. I normally buy them for $20-$100 if no speed changer, joiner or jigsaw. If no metal ends and/or retractable casters, then $50 is the most I will pay for an average run-of-the mill 10E/10ER. For a totally restored one with all accessories and new paint, then $200-$300 is not bad. They make an excellant drill press and a cheap way to start doing some wood working. All 10E/10ER parts can be replaced/repaired/rebuild and they last forever if you take care of the rust and corrosion.

matthew wrote:Can Anyone Tell Me What A Model 10e Is Worth,

"...they last forever..."

And, with a little encouragement, they will clone new, improved copies of themselves. We use about two dozen 10E's in the manufacture of Shopsmith Mark Vs.

With all good wishes,

Thanks For The Replys On The 10e.

We use about two dozen 10E's in the manufacture of Shopsmith Mark Vs.

Is that true Nick? That's remarkable - How are they used? Photo's of the SS manufactring process would be awesome!! Alec

I just picked up 10ER with jigsaw but w/o coupling or blades. Are couplings available from SS and what type blades should I be looking for?

I paid $100.00 with jigsaw-runs pretty good. It's a lot heavier than my
56' MK 500.

I am the proud new owner on a 10E. I'd like to replace the motor. What would you suggest. Where do you suggest I look for one. Thanks in advance for your help. Chas