Shopsmith Forums

rpd wrote: ↑Wed Nov 17, 2021 11:30 am Storing sanding disks.
None of mine have ever come loose, but if yours do, this is a solution.

Video was removed from YouTube. I never got to see it. What was problem and solution here?

edma194 wrote: ↑Tue Dec 07, 2021 10:50 am

rpd wrote: ↑Wed Nov 17, 2021 11:30 am Storing sanding disks.
None of mine have ever come loose, but if yours do, this is a solution.

Video was removed from YouTube. I never got to see it. What was problem and solution here?

I was puzzled as to it's disappearance too.

It didn't look like something I would do, so I didn't pay close attention. I recall, he found that the outer edges of the paper on the sanding disks could lift off a bit, sawdust would get underneath, and then the edge wouldn't stick down again.
For the conical disk he made a matching conical depression in a board and lined it with something soft, like shelf liner, same but flat for the flat disks,
and stored the disks face down, with weights on them, to keep pressure on them while stored so the adhesive maintained contact.

[youtube]https://youtu.be/MlGXfJ8dmjg[/youtube]
The Storing your conical sanding disc video was re-uploaded by Dave.

https://youtu.be/MlGXfJ8dmjg
The Storing your conical sanding disc video was re-uploaded by Dave.

Mike Young. Updates and a tip on how to remove and replace the paper on sanding disks.

Making a tooth shaped bandsaw box, for keeping a child's lost teeth.

Making wooden top's and trucks for Christmas presents.

Mike Young shows how to efficiently change between setups.

Designing a rack to hold barbells.

dc motor controller