Page 1 of 1
Anybody have a Shopsmith Mark VII and willing to help me ou
Posted: Sun Mar 26, 2017 10:50 am
by dragonman57
Hello,
I am trying to make a part for my Shopsmith Mark VII. There is no speed control cam and I do not have the original part. Can anybody give me the dimensions for the part? Any help would be greatly appreciated.
Thank you
Re: Anybody have a Shopsmith Mark VII and willing to help me ou
Posted: Sun Mar 26, 2017 11:47 am
by rpd
This link should help.
http://www.shopsmith.com/ss_forum/maint ... 14452.html
There is a link to a PDF file in the last line of the first post that should give you the information you seek.
Re: Anybody have a Shopsmith Mark VII and willing to help me ou
Posted: Sun Mar 26, 2017 11:50 am
by dragonman57
Awesome! Thank you!
Re: Anybody have a Shopsmith Mark VII and willing to help me ou
Posted: Sun Mar 26, 2017 11:52 am
by JPG
The best I could do would be a tracing and a rough sketch with dimensions.
However there are members who possible have far better information.
One in particular has 3D printed one.
If no one else responds, I will try to help.
Re: Anybody have a Shopsmith Mark VII and willing to help me ou
Posted: Sun Mar 26, 2017 12:04 pm
by rpd