Page 1 of 1
Motor slowing down
Posted: Sun Apr 23, 2017 11:08 am
by woodmeister
Have a person who has a mark v and it bogs down when cutting on table saw position. The motor runs he say but wonder if it a belt slipping or something else? Anyone have suggestions?
Thanks,
Tom
Re: Motor slowing down
Posted: Sun Apr 23, 2017 11:35 am
by JPG
woodmeister wrote:Have a person who has a mark v and it bogs down when cutting on table saw position. The motor runs he say but wonder if it a belt slipping or something else? Anyone have suggestions?
Thanks,
Tom
Poly-V belt slipping.
Re: Motor slowing down
Posted: Sun Apr 23, 2017 3:11 pm
by woodmeister
is the proper way to tighten it by rotating the eccentric clock wise direction? About 930 - 1000 O'clock position?
Re: Motor slowing down
Posted: Sun Apr 23, 2017 5:16 pm
by JPG
woodmeister wrote:is the proper way to tighten it by rotating the eccentric clock wise direction? About 930 - 1000 O'clock position?
Rotate CW until it does not slip.
If it gets to 12, the belt needs to be replaced.
Do NOT over tighten the clamping screw.
Re: Motor slowing down
Posted: Sun Apr 23, 2017 9:53 pm
by woodmeister
THANK YOU