Page 1 of 1
My little shop
Posted: Wed Sep 06, 2017 8:23 pm
by Danriffle
Small, but packed with shopsmithy goodness!
Re: My little shop
Posted: Wed Sep 06, 2017 9:27 pm
by Danriffle
An explanation of the clutter:
In the extreme foreground, the handle of my Yuba Sawsmith.
Clamped to the saw table is a spare 10er table with shaper fence.
Foreground is a 10E (primarily TS and dado duty).
Has a 3/4 HP 3450 rpm motor and 2 step drive pulley.
Hiding behind that is a MkV, my newest acquisition.
It came with a bandsaw. Still putting it through it's paces.
Completely hidden against the right wall is another 10ER.
It's the lathe, disk & drum sander, and horizontal drill press.
In the corner is yet another 10ER as a dedicated drill press.
(Not pictured, still another 10ER that I have on a job site.)
Re: My little shop
Posted: Wed Sep 06, 2017 9:54 pm
by Dansmith
You must really like 10er's.
What's not to like?
Nice shop.
Re: My little shop
Posted: Wed Sep 06, 2017 10:09 pm
by Danriffle
Dansmith wrote:You must really like 10er's.
What's not to like?
Nice shop.
Exactly! And thanks!
Re: My little shop
Posted: Wed Sep 06, 2017 10:18 pm
by masonsailor2
Nice shop ! Best part is it is obviously used a lot.
Paul
Re: My little shop
Posted: Wed Sep 06, 2017 10:26 pm
by Danriffle
masonsailor2 wrote:Nice shop ! Best part is it is obviously used a lot.
Paul
Thanks! I do make mountains of sawdust!
Re: My little shop
Posted: Wed Sep 06, 2017 11:00 pm
by JPG
An interesting 'addition'!
- holddown.jpg (2.93 KiB) Viewed 7568 times
Re: My little shop
Posted: Wed Sep 06, 2017 11:11 pm
by Danriffle
JPG wrote:An interesting 'addition'!holddown.jpg
Ha,ha! These machines are designed for ingenuity.
That's a hold down I use for dadoes. It's cobbled together from a blade guide from a old 10er scroll saw, parts from an old SS universal hold down set and an ancient spring loaded rubber caster that appeared in my junk bin at some point.
It works surprisingly well!