Page 1 of 1
New Video From Shopsmith
Posted: Fri Nov 24, 2017 5:29 am
by joe_cool
Looks like Shopsmith just released a new video on Youtube on how to do the DIY PowerPro Upgrade.
https://www.youtube.com/watch?v=xCLkH6T1uQE
Re: New Video From Shopsmith
Posted: Sat Nov 25, 2017 10:30 am
by number3456
That's the video of the dvd that comes with pp upgrade. good that they finally posted it online.
Re: New Video From Shopsmith
Posted: Sun Nov 26, 2017 1:37 pm
by JPG
I noticed Jim using a piloted countersink bit. Any one know what size it is?
I assume it comes with the upgrade bits. 1/4" pilot???????????
Re: New Video From Shopsmith
Posted: Mon Nov 27, 2017 12:04 pm
by number3456
The countersink bit comes with the kit.
Re: New Video From Shopsmith
Posted: Mon Nov 27, 2017 2:33 pm
by jsburger
Very good video. There is only one ooops that I noticed. During installation of the power supply he installs a clip under one of the power supply brackets to hold the power cord. In the next scene where he installs the locking wedges and for the entire rest of the video that clip is not there.
Re: New Video From Shopsmith
Posted: Mon Nov 27, 2017 2:54 pm
by JPG
number3456 wrote:The countersink bit comes with the kit.
Size of the pilot? 1/4"???
Re: New Video From Shopsmith
Posted: Mon Nov 27, 2017 2:56 pm
by JPG
jsburger wrote:Very good video. There is only one ooops that I noticed. During installation of the power supply he installs a clip under one of the power supply brackets to hold the power cord. In the next scene where he installs the locking wedges and for the entire rest of the video that clip is not there.
It has been mentioned before, but that sharp pointy screw near the possible location of the wire bundle scares the bejabbers out of me.