Shopsmith Forums

I have all of my documentation packed away for the pending move which will commence today when our POD is delivered. However, I need to adjust the vertical slide bar that guides the upper backup bearing(s).

If someone would send me by email or post here on the forum a copy of the Shopsmith procedure for accomplishing this task, it would be greatly appreciated. I have attempted this alignment without the procedure and I have my bandsaw really screwed up. Just that portion of the procedure that covers this task. I don't need the whole manual.

I have extracted the instructions for this task from a thread on the forum but I would also like to reread the Shopsmith instructions. I have attempted this procedure several times and every time given up. I get it close but never like I think it should be. With my shop temporarily out of commission I need tasks that I can use to occupy my time. This seems like a good starter.

While we are waiting for the new residence I hope to have access to my Shorty, bandsaw, belt sander and maybe jointer. Just those items that can be kept within the footprint of the Shorty.

http://www.shopsmith.com/ss_forum/viewt ... 96#p242996

Shopsmith has the bandsaw manual online now, Dusty.

http://www.shopsmith.com/ownersite/manuals/845539.pdf

Thank you very much. This is greatly appreciated and I embarrassed to admit that I completely overlooked this data resource. This makes my day.