Page 1 of 1
any one in PA
Posted: Fri Jan 26, 2018 8:33 am
by Hobbyman2
Re: any one in PA
Posted: Fri Jan 26, 2018 12:53 pm
by JPG
When the bench tubes are inserted into the base correctly, the available width is shorter(they are not inserted fully in the pix).
26" is very short, but 'ok' if no carriage.table is used.
Re: any one in PA
Posted: Sat Jan 27, 2018 12:09 am
by Hobbyman2
Thanks ,,,,If I were closer I would have been on this for that kind of money and set it up for SPT storage.
Re: any one in PA
Posted: Sat Jan 27, 2018 10:01 am
by JPG
Hobbyman2 wrote:Thanks ,,,,If I were closer I would have been on this for that kind of money and set it up for SPT storage.
Somebody got a deal if local pickup was an option!