Page 1 of 1
For those who find angle cutting...
Posted: Thu Feb 08, 2018 10:41 am
by Gene Howe
...as challenging as I do.
[youtube]
https://m.youtube.com/watch?v=v3eiMpnBg0c [/youtube]
Re: For those who find angle cutting...
Posted: Thu Feb 08, 2018 11:07 am
by dusty
I would not have admitted that cutting odd angles is a challenge but maybe that was because I never needed the angles that exceed my miter capability.
Thanks for posting this. I found it very interesting and even though the OP was using a miter saw, the same techniques will apply to the Shopsmith.
Re: For those who find angle cutting...
Posted: Thu Feb 08, 2018 2:46 pm
by terrydowning
Thanks Gene, nice primer on acute angles.
Re: For those who find angle cutting...
Posted: Thu Feb 08, 2018 4:29 pm
by joedw00
Thanks for sharing!!
Re: For those who find angle cutting...
Posted: Thu Feb 08, 2018 8:27 pm
by JPG
Who will be the one to demonstrate this on a SS?
Re: For those who find angle cutting...
Posted: Fri Feb 09, 2018 4:13 pm
by reible
One of the guys I follow on youtube just posted a similar video. You might like to check it out but more important check the comments...... you have to know your audience.
https://www.youtube.com/watch?v=BIgJoyia598
If this was the only video you watch of his you would be missing out on a lot of good stuff so take a moment and try a couple more, I think you will like them. Yea he gets commercial but I can take it.
Ed