Page 1 of 1
Another tiny turning
Posted: Tue Apr 17, 2018 11:38 pm
by masonsailor2
Had a small piece of black walnut and decided to make a small ring cup.
Paul
Re: Another tiny turning
Posted: Wed Apr 18, 2018 12:28 am
by rudy49
Very nice
Re: Another tiny turning
Posted: Wed Apr 18, 2018 8:24 am
by reible
I like it! Might be a good way to use up some smaller left overs.
Was it a faceplate turning? Can't see how you might have chucked it from the pictures.
Ed
Re: Another tiny turning
Posted: Wed Apr 18, 2018 9:01 am
by JPG
Looks like a job for a screw center.
Re: Another tiny turning
Posted: Wed Apr 18, 2018 9:47 am
by rpd
On the second photo there looks to be a tenon on the bottom.
Re: Another tiny turning
Posted: Wed Apr 18, 2018 9:55 am
by reible
rpd wrote:On the second photo there looks to be a tenon on the bottom.
Or a glue block?? That is why I ask because it would seem there could be various ways of doing this. I was think of how I would do it with the bottle stopper mandrel I have from Ruth but I like to learn how others might do it.
Ed
Re: Another tiny turning
Posted: Wed Apr 18, 2018 12:08 pm
by masonsailor2
I turned it with a chuck. There is a small tenon on the bottom.
Paul