I have a Mark V. When I follow the video that came with it to align it, the table binds when I try to rotate it 90 degrees into drill press mode, which comes part way through the alignment process. Any suggestions?
I can relieve some of the binding by adjusting the bolts holding on the table, but not enough.
Table binding during alignment
Moderator: admin
Re: Table binding during alignment
Is this the video you watched.
[youtube]https://www.youtube.com/watch?time_cont ... DxLtQIP1kQ[/youtube]
If not, watch this one, be sure to note the dollar bill trick starting at 12:50.
[youtube]https://www.youtube.com/watch?time_cont ... DxLtQIP1kQ[/youtube]
If not, watch this one, be sure to note the dollar bill trick starting at 12:50.
Ron Dyck
==================================================================
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,
==================================================================
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,
-
dusty
- Platinum Member
- Posts: 21481
- Joined: Wed Nov 22, 2006 6:52 am
- Location: Tucson (Wildcat Country), Arizona
Re: Table binding during alignment
What is actually happening is the table tilt locks are fully engaged. The dollar bill trick mentioned in the previous post alleviates that.
"Making Sawdust Safely"
Dusty
Sent from my Dell XPS using Firefox.
Dusty
Sent from my Dell XPS using Firefox.