A couple of SO jigs
Posted: Sat Oct 13, 2018 5:22 pm
Used the SO to make them, just some scraps of MDF about 12" by 15"-16".
The jig sits on the work piece for doing things like engraving. Here was my proof of concept test:
Since the work piece was a cut off I had to add some other cut offs to get it to sit flat but that could let me use up these smaller pieces.
Nothing earth shacking but I think this will be very useful for me.
Ed
- 20181013_155528_resized.jpg (233.71 KiB) Viewed 5949 times
- 20181013_153022_resized.jpg (227.69 KiB) Viewed 5949 times
- 20181013_153036_resized.jpg (201.14 KiB) Viewed 5949 times
Ed