Page 1 of 1
Bandsaw
Posted: Sat Aug 30, 2008 1:09 am
by putttn
Wondered if there is a video on aligning/operating the bandsaw? I have the manual on a 1990 model I just purchased but seeing it done it quite a bit easier for me.
Posted: Sat Aug 30, 2008 10:30 am
by beeg
Posted: Sun Sep 07, 2008 11:35 am
by putttn
I did find a tune up video. Went to Ebay and searched for Shopsmith Video and found one by Jacob Anderson that covers the tuneup/alignment of the bandsaw.
Some interesting comments on the urethane tires and bearings. Seems like there is a rpm limit on the urethane tires. The older bearings are pretty good too.
Posted: Mon Sep 08, 2008 1:36 am
by curiousgeorge
Putttn,
Here is a 1hr 10min video podcast on band saws. You can download it or watch it on-line. It's very informative. Just go to podcast #22 "Buying and getting the most out of your band saw". It's not about the Shopsmith, but a band saw is a band saw. Hope this helps.
http://www.woodworkingonline.com/catego ... st/page/2/