Tailstock extension

This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.

Moderators: HopefulSSer, admin

gpuckett
Bronze Member
Posts: 5
Joined: Fri Jul 03, 2020 6:51 pm

Re: Tailstock extension

Post by gpuckett »

To improve the ease of use and functionality I made some modifications.
First, I made a top access to the Tool Post locking mechanism.
Second, reduce a little weight.
Third, provided a handle.
Attachments
Extension with opening 1.JPG
Extension with opening 1.JPG (29.44 KiB) Viewed 3483 times
Extension with opening 2.JPG
Extension with opening 2.JPG (25.62 KiB) Viewed 3483 times
Extension with opening 3.JPG
Extension with opening 3.JPG (24.73 KiB) Viewed 3483 times
scollins
Gold Member
Posts: 106
Joined: Sun Sep 21, 2008 8:15 am
Location: Chapel Hill, TN

Re: Tailstock extension

Post by scollins »

Tailstock extension is a sweet addition.
scollins
Gold Member
Posts: 106
Joined: Sun Sep 21, 2008 8:15 am
Location: Chapel Hill, TN

Re: Tailstock extension

Post by scollins »

Finally figured out a working lathe extension. I fitted a 6x6 post into the 20" way extension on my Nichols ~1200 lb. lathe anchoring it to a cross bar in the way using a lag bolt and big washer. I cut two pieces of angle iron and attached them to the other end and fitted the 6x6 to the tail stock end of my shopsmith. Two 6" Irwin Quick Grip clamps on the flat spot on the inside of the SS leg and the angle iron brackets secure the SS to the 6x6. I show a blurred 60" shaft running with this set up in the pic. Notice that the SS is not blurred meaning no vibration! If there was vibration, these clamps would pop off. I had salvaged an old Delta tail stock which fits perfectly on the Nichols and matched the center point on the SS :) .

This is a truly unique solution in my situation using what I have sitting around my shop.
Attachments
Lathe Extension (2).jpg
Lathe Extension (2).jpg (145.36 KiB) Viewed 809 times
Lathe ext 2.jpg
Lathe ext 2.jpg (26.96 KiB) Viewed 809 times
Jd1a
Bronze Member
Posts: 5
Joined: Sat Nov 21, 2020 1:52 pm

Re: Tailstock extension

Post by Jd1a »

Long lathe.
Jd1a
Bronze Member
Posts: 5
Joined: Sat Nov 21, 2020 1:52 pm

Re: Tailstock extension

Post by Jd1a »

Good job, gpuckett
Post Reply