Page 1 of 1
Arbor with male 5/8" thread end to use regular saw blades
Posted: Wed Feb 19, 2020 6:07 pm
by GPelham
I just picked up a used Mark V and it came with the shopsmith 1 1/4 inch arbor and a very old blade. I have many 10 in blades for my miter, radial arm and table saws and would like to use them with the MV table saw. On line I can only find the adapter with a 1 inch threaded end, which is needed for lathe attachments so I bought one. Anyone know where to purchase one with 5/8 inch thread?
Thanks
Gary
Re: Arbor with male 5/8" thread end to use regular saw blades
Posted: Wed Feb 19, 2020 6:15 pm
by jsburger
Re: Arbor with male 5/8" thread end to use regular saw blades
Posted: Wed Feb 19, 2020 6:21 pm
by GPelham
Thank You,
Re: Arbor with male 5/8" thread end to use regular saw blades
Posted: Thu Feb 20, 2020 12:53 pm
by chapmanruss
You did not say which Mark V you have and it can make a difference on which 5/8" Blade Arbor to get. The original Mark V aka 500 uses a shorter Arbor than the Mark V 510, 505, 520 and Mark 7. Both are listed on the link John gave you.
Re: Arbor with male 5/8" thread end to use regular saw blades
Posted: Fri Feb 21, 2020 9:28 am
by GPelham
Thank You as well for helping a newbee