Page 1 of 1
Band Saw Box Demo
Posted: Thu Mar 05, 2020 1:56 pm
by RobertTaylor
On February 8, 2020 I did a demo for The Buckeye Woodworkers and Woodturners on making Band Saw Boxes. Even though the Club has a decent 14"Delta I chose to take my own Shopsmith band saw. If interested take a look at the write-up in the Club's newsletter
https://www.bwwt.us/uploads/7/0/5/0/705 ... 0_bwwt.pdf
Re: Band Saw Box Demo
Posted: Thu Mar 05, 2020 5:46 pm
by reible
Do you have your bandsaw on a stand or did you have to bring a whole machine?
Good to use machines you know and maybe good pr for shopsmith.
I haven't made a bandsaw box in years, should give it a go again this summer, maybe the one like the log you did.
Ed
Re: Band Saw Box Demo
Posted: Thu Mar 05, 2020 7:33 pm
by RobertTaylor
Thanks Ed. This band saw is on a Shopsmith stand. Bob
Re: Band Saw Box Demo
Posted: Fri Mar 06, 2020 10:26 am
by JPG
Have you shimmed the table to make the blade perpendicular to the table 'front to rear'(tooth to spine) or did you only check for table 'tilt'?
mar_2020_bwwt.pdf